WarmlyYours ERT120-1.5x18 Manuel d'instructions télécharger pdf

SHEATH

CORE

Black Inner Lead

Yellow (120V)

or Red (240V)

Inner Lead

Copper

Ground Sheath

BLACK

GREEN

(Sheath)

RED

SHEATH

CORE

Black Inner Lead

Yellow (120V)

or Red (240V)

Inner Lead

Copper

Ground Sheath

BLACK

GREEN

(Sheath)

RED

Paperclip

TESTING THE CIRCUIT CHECK

1. LAY OUT THE WARMLYYOURS WARMING SYSTEM ROLL(S)

Lay out the roll(s) in accordance with the design layout and instructions provided by WarmlyYours.

2. TEST THE CIRCUIT CHECK DEVICE

Before connecting any wires, install the batteries in the device and turn it "on" and "off" to test

the alarm. The unit should alarm when disconnected and powered “on”.

After confirming that the alarm is in good working order, connect the wires as follows:

- Connect Black inner conductor core wire to the Black terminal.

- Connect 2nd inner conductor core wire to the Red terminal.

THERE ARE TWO WAYS OF DOING THE NEXT STEP:

2.1 Split the ground sheath in two, connect one half of the ground sheath to the green terminal,

turn on the Circuit Check and touch the other half of the ground shealth to one of the inner

conductor wires;

2.2 Install the entire ground into the green terminal. Turn on unit and use a paper clip as a bridge

between the ground wire and either one of the inner conductors.

Either method should activate the alarm. If the Circuit Check does not pass all these tests,

please call WarmlyYours Customer Service at (800) 875-5285.

Please turn over to view detailed illustrations for wiring

Tempzone to the Circuit Check

Note

: This device is NOT an Ohm meter. WarmlyYours requires that the roll be tested before, during and after

installation with a Digital Ohm meter.

Circuit Check Device

Testing and Installation

Installation Support •(800) 875-5285 • www.WarmlyYours.com

1 2

Circuit Check Device 1

Résumé du contenu

Page 1 - Circuit Check Device

SHEATH CORE CORE Black Inner Lead Yellow (120V) or Red (240V)Inner LeadCopper Ground SheathBLACKGREEN(Sheath)RED SHEATH CORE CORE Black Inner Lead Ye

Page 2

Wiring Tempzone to Circuit CheckSHEATH CORE CORE Black Inner Lead Yellow (120V) or Red (240V)Inner LeadCopper Ground SheathON OFF BLACKGREE

Plus de documents pour Accessoires pour motos WarmlyYours ERT120-1.5x18

Voir le document WarmlyYours ERT120-1.5x18 Guide d'installation

WarmlyYours ERT120-1.5x18 Guide d'installation (14 pages)

Commentaires sur ces manuels

Pas de commentaire

WarmlyYours ERT120-1.5x18 Manuel d'instructions

Naviguer en ligne ou télécharger Manuel d'instructions pour Accessoires pour motos WarmlyYours ERT120-1.5x18. WarmlyYours ERT120-1.5x18 Circuit Check Instructions Manuel d'utilisatio

Résumé du contenu

Plus de documents pour Accessoires pour motos WarmlyYours ERT120-1.5x18

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour motos WarmlyYours ERT120-1.5x18