Warmlyyours Environ Flex Roll System For laminate/floating woo Manuel d'utilisateur télécharger pdf (Page 8)

Installing The Thermostat

If you are using a thermostat with a oor sensor, place the sensor under the Environ™ Flex Rolls, centered between two heat wires, at least 6” (150 mm) into the

heated area.

Make a small divot in the underlayment in this spot and secure the sensor head in the divot with tape. Run the sensor cable in a channel cut into the underlayment

from the heater and back to the thermostat. The “heater wires” within the roll are identied as raised parallel lines. The sensor wire should not cross over the foil heater

wires, and is better placed in a channel cut into the underlayment, under the roll.

HOT

THERMOSTAT SENSOR

(LOW VOLTAGE)

FROM POWER SOURCE 120V & 240V

SENSOR

Front

PB112C-GA

ENSURE THE SYSTEM IS GROUNDED

HOT (240V) or

NEUTRAL (120V)

HOUSE GROUND

Red (240) or

Yellow (120) Wires

Red

Black

Red

Copper

Ground

4x4 Box

Black

Black Lead

THERMOSTAT

Load

L2 (N)

L1 (L)

RED

BLACK

SENSOR

GROUND

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire

Warmlyyours Environ Flex Roll System For laminate/floating woo Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la maison Warmlyyours Environ Flex Roll System For laminate/floating woo